128
Note:
During the wear check (to be performed
according to the maintenance table shown at pp.
57-58 of this manual), it is necessary to thoroughly
check the bottom of the tooth groove for cracks
(see example «A» shown in figure). If cracks are
detected the belt must be replaced. Also ensure
that no deformations are present.
10.7.20
Checking the Clutch Friction Material
-
Measure the thickness of the clutch shoes friction
material.
Min. allowable dimension:
Clutch shoe thickness
0.04 in
(
1 mm
)
Note:
Ensure that the clutch shoes bear no traces
of lubricant. If they do, check the seal of the driven
pulley assembly.
Note:
Upon the running-in period, the clutch shoes
must have a central contact surface and must not
differ from one another, otherwise the clutch may
slip.
Warning
– Do not use a tool to open the shoes as
this may affect the return spring load.
10.7.21
Fitting the Clutch
-
Place the driven pulley onto the compressor tool,
as shown in the figure, so that the control screw
is in a vertical position.
-
Prepare the tool with the medium length pins
screwed in position «C» on the inside.
-
Introduce the adapter ring no. 11 with the
chamfering facing upwards.
-
Insert the clutch on the adapter ring.
-
Lubricate the end of the spring that abuts
against the servo-system closing collar.
Summary of Contents for GT 200
Page 1: ......
Page 90: ...90 9 1 2 Turn Signal Lights Horn Services and Accessory Pre Wiring ...
Page 151: ...151 10 10 Lubrication Circuit ...
