129
Note:
An excessive amount could impair the clutch
functions.
-
Insert the spring with relevant plastic support in
contact with the clutch.
-
Insert the driving belt into the pulley unit
according to their direction of rotation.
-
Insert the pulley unit with the belt into the tool.
-
Slightly pre-load the spring.
-
Make sure that the clutch is perfectly inserted
10.7.22
Checking the Moving Driving Half-Pulley
Check that the bearing shown in the figure is not
worn and measure the internal diameter.
Standard dimension:
Internal bearing diameter
∅
1.0140-1.0148 in
(
26.000-26.021 mm
)
Max. allowable dimension:
Internal bearing diameter
∅
1.0283 in
(
26.12 mm
)
Warning
- Do not lubricate or clean the bushes.
-
Measure the pulley sliding bushing external
diameter shown in the figure.
Standard dimension:
Bushing external diameter
Ø 1.0220-1.0228 in
(
25.959-25.980 mm
)
Min. allowable dimension:
Bushing external diameter
Ø 1.0217 in
(
25.950 mm
)
Summary of Contents for GT 200
Page 1: ......
Page 90: ...90 9 1 2 Turn Signal Lights Horn Services and Accessory Pre Wiring ...
Page 151: ...151 10 10 Lubrication Circuit ...
