147
-
Prepare the flywheel cover by aligning the
reference marks between the drive and the
cover casing.
-
Fit the cover on the engine. Insert the three
studs in the water pump drive.
-
Follow the operations for the removal in the
reverse order.
Warning
– Take care to properly position the
flywheel connector. Make sure of the presence of
the two dowel bolts.
-
Replace the plastic support for the secondary air
box valve and tighten wit the prescribed torque.
Tightening torques:
Flywheel fixing nut
2.2-2.9 lbs·ft
(
3-4 N·m
)
-
Replace the secondary air box valve with its
gasket and tighten with the prescribed torque.
Tightening torques:
Secondary air box valve screw
2.2±0.4 lbs·ft
(
3
±0.5
N·m
)
-
Replace the rubber sleeve and the metal pipe
connecting the SAS valve to the exhaust.
-
Check the correct orientation by aligning the two
references, on the rubber and on the plastic
support, as shown in the figure.
Summary of Contents for GT 200
Page 1: ......
Page 90: ...90 9 1 2 Turn Signal Lights Horn Services and Accessory Pre Wiring ...
Page 151: ...151 10 10 Lubrication Circuit ...
