159
-
Place the cover onto the engine crankcase and, by tightening the three screws (with
copper washers) with the prescribed torque, fix the cover to its seat.
Tightening torques:
Chain cover fixing screw
2.6-3.3 lbs·ft
(
3.5-4.5 N·m
)
10.10.8
Fitting the By-Pass and the Oil Sump
-
Fit the by-pass piston in its seat.
-
Insert the adjusting spring.
-
Fit a new sump gasket.
-
Fit the two dowel bolts.
-
Install the sump taking care to insert the spring
into the projection in the sump.
-
Fit the screws and the rear brake pipe clamps by
following the removing procedure in the reverse
order.
-
Tighten the screws with the prescribed torque.
Tightening torques:
Oil sump screws
7.4-10.3 lbs·ft
(
10-14 N·m
)
-
Fit the driving pulley assembly, the belt, the
pinion and the transmission cover as described
in the chapter “Transmission”.
-
Regarding the checks relating to the lubrication
of the connecting rod assembly, refer to the
chapter “Crankcase and Crankshaft”.
10.10.9
Removing the Intake Manifold
-
Remove the flywheel cover assembly.
-
Loosen the three screws and remove the intake
manifold.
Summary of Contents for GT 200
Page 1: ......
Page 90: ...90 9 1 2 Turn Signal Lights Horn Services and Accessory Pre Wiring ...
Page 151: ...151 10 10 Lubrication Circuit ...
