220
10.12.2
Removing the Water Pump
-
If the bearings are noisy or any liquid leaks
from the drain hole inside the cover, proceed
to overhaul the water pump.
-
Remove the flywheel cover with the water
pump from the engine.
-
Remove the impeller cover after unscrewing
the three fastenings shown in the figure.
-
Position the flywheel cover on the ring-shaped base that is part of tool part no. 020440Y.
Specific tools and equipment:
Ring base
020440Y
Note:
To prevent damage to the cover surface designed to ensure coolant tightness, use the
ring-shaped base with the accurately machined surface facing the flywheel cover.
-
Using a press and the drift that is part of tool
no. 020440Y, eject the shaft complete with the
impeller from the drive and the bearing.
Summary of Contents for GT 200
Page 1: ......
Page 90: ...90 9 1 2 Turn Signal Lights Horn Services and Accessory Pre Wiring ...
Page 151: ...151 10 10 Lubrication Circuit ...
