229
-
Remove the rear handlebar cover.
-
Remove the screw fixing the handlebar to the
steering column.
-
Carefully rest the rear handlebar cover against
the leg-shield, paying attention not to scratch
any plastic parts.
-
Remove the steering column ring nut cover.
-
Remove the counter ring nut, the spacing
washer and the top steering column ball-cage
bearing seat ring nut.
-
Extract the steering column and remove the
mudguard from the suspension.
Specific tools and equipment:
Steering column ring nut spanner
020055Y
-
For re-assembly, follow the operations for removal in the reverse order, carefully applying
grease on the steering column ball-cage bearing seats and tightening at the prescribed
torques.
Tightening torques
:
Upper ring nut
21-28 lbs·ft
(
30-40 N·m
)
Lower ring nut
6-7 lbs·ft
(
8-10 N·m
)
Handlebar-steering column
32-35 lbs·ft
(
45-50 N·m
)
Summary of Contents for GT 200
Page 1: ......
Page 90: ...90 9 1 2 Turn Signal Lights Horn Services and Accessory Pre Wiring ...
Page 151: ...151 10 10 Lubrication Circuit ...
