54
7.2
Carburetor
-
Disassemble all carburetor components, ac-
curately wash them in solvent, and then dry
them with compressed air. To ensure
thorough cleaning, pay particular attention
to the passages in the carburetor body.
-
Carefully check the conditions of each
component.
-
The throttle valve must slide freely into the
chamber; in case of excessive play due to
wear, replace the valve.
-
Replace the carburetor if the chamber shows
excessive signs of wear as to preclude the
valve’s regular seal or free sliding (even if
new).
-
Gaskets should be replaced every time the
carburetor is reassembled.
Warning
- Fuel is highly explosive. Always re-
place gaskets to prevent leakage.
1
. Diaphragm cover -
2
. Throttle valve spring -
3
. Conical needle support -
4
. Conical needle
spring -
5
. Conical needle -
6
. Throttle valve
diaphragm -
7
. Automatic choke -
8
. Idle speed
adjusting screw -
9
. Return valve rockers -
10
. Idle mixture adjusting screw -
11
. Float pin
-
12
.Return pump unit -
13
. Float -
14
. Float
chamber -
15
. Idling jet -
16
.Main jet -
17
. Diffuser -
18
. Float chamber drain screw.
Summary of Contents for GT 200
Page 1: ......
Page 90: ...90 9 1 2 Turn Signal Lights Horn Services and Accessory Pre Wiring ...
Page 151: ...151 10 10 Lubrication Circuit ...
