60
-
Lubricate the O-rings and replace net filter
and oil drainage cap; tighten at the
prescribed torque.
-
Install the new cartridge filter after
lubricating the O-ring.
-
Fill with fresh engine oil.
-
Since a certain quantity of oil still remains
in the circuit, the fill-up should be carried
out with about 0.64 quarts (
600-650 cm
3
)
of oil from cap
«A»
. Subsequently, start
up the engine, let it idle for a few minutes
and then switch it off. After about 5
minutes, check the level and top up if
necessary
without ever exceeding the
MAX mark
. The cartridge filter must be
replaced every time the oil is changed. For
top ups and replacements, use fresh
Selenia HI Scooter 4 Tech
oil.
Note:
Engine oil should be replaced when the
engine is hot.
Tightening torque:
Engine oil drainage cap
17.6-22.1 lbs·ft
(
24-30 N·m
)
Recommended oil:
Selenia HI Scooter 4 Tech
Summary of Contents for GT 200
Page 1: ......
Page 90: ...90 9 1 2 Turn Signal Lights Horn Services and Accessory Pre Wiring ...
Page 151: ...151 10 10 Lubrication Circuit ...
