66
-
Push the bolt lightly and extract the
retainer from the milled part shown in the
figure.
-
Extract the bolt assembly from the lock
body.
-
To refit, follow the reverse procedure.
7.9.2
Removing the Steering Lock when on «LOCK» Position
The bolt retaining spring is not accessible in
the «LOCK» position. It is then necessary to
drill the bolt as shown in the figure to eject it.
Note:
To refit the bolt from this position, first
disengage the steering lock by putting the
lock body (inner and outer part) in the OFF
position.
To refit, proceed as described in the previous
paragraph.
Summary of Contents for GT 200
Page 1: ......
Page 90: ...90 9 1 2 Turn Signal Lights Horn Services and Accessory Pre Wiring ...
Page 151: ...151 10 10 Lubrication Circuit ...
