6
7
Assembly
Follow the assembly steps in the order listed below.
❶ Insert the steering column/axle assembly up through
the fender and on through the handlebar opening.
❷ Align the holes in the neck of the fender with the
bottom holes on the steering column. Secure with the
small screw and nut.
❸ Insert the handlebar inset up into the handlebar
assembly.
❹ Connect the handlebar wire connector to the wire
connector coming from the handlebar opening.
❺ Fit the handlebar assembly over the end of the
steering column. Secure with the large screw and nut.
❻ Press the button on the training wheel and insert the
end of the training wheel into the square training wheel
bracket until the button on the training wheel snaps
into the hole in the square tube.
❼ Attach the front wheel assembly to the front axle.
❽ Place the seat over the storage area. Fasten with the
medium screw and nut. Note: press the button on the
back of the seat to flip it open.
❾ Insert each mirror down into the mirror slots located
on each side of the handlebars.
❿ Remove the battery compartment cover and make the
one-time connection. (See page 8.)
⓫ Charge the battery. (See page 9.)
Use the wrench (included)
to tighten the wheel nut.
❼
❻
❹
❶
❷
❸
Completely align the holes in the steering column
with the holes in the handlebar assembly.
Inserting the training wheel is best performed
from the under-side of the scooter.
❺
❽
❾
❿
⓫
Summary of Contents for KT1510
Page 1: ......
