Vessel F-6R, Instruction Manual

25 



 Before Use

Connector connection 

Insert the included special AC adapter connector into the jack on the 
back of the body. 

Power Supply Adapter 

Use the power adapter (AD24-ITF6) which is specifically designed for 
use of F-6R. 
The AC adapter plug is a 3-pronged plug. 
Connect this to a power outlet that has a ground terminal. 

Daily Checks 

Check F-6R for inspection before use.



Dust on electrodes 



Dirty filter 



Loose connector 



Damaged or loose parts 



Adhering condensation or water droplets 

If damage or trouble is detected, contact the supplier for servicing. 
 



 Operation

POWER 

This is used to start and stop the unit. 
When switched to [ - ], the power is turned on and 
operation starts. 
When switched to [ o ], the power is turned off and 
operation stops. 
A built-in high-intensity white LED is provided to 
visually check if the discharge needles are dirty. 
* The internal lighting turns on at the same time the 
power is turned on. (Low power consumption) 

FAN SPEED

Fan speed can be changed by two steps; "HI", "LO". 

ALARM LAMPS 

H.V.ALARM

（

High voltage alarm lamp

）

High voltage alarm lamp lights when electrode needle is grounded, short circuited, or high voltage 
booster unit does not output enough voltage. If any foreign object attached to the electrode 
needles. Please refer to the "How to Clean the Electrode needle" on page 11. 
(In case abnormally high voltage is detected, the output from the transformer will be stopped. 
However, the fan will be kept operating.) 

FAN ALARM 

Fan lock alarm lamp lights when the fan motor stops rotating. When any of the alarm lamps 
lights, 
unplug the power cable and check the following items. If any foreign object inserted into the fan 
motor. Removing the cause of the error, supply power again and check if the alarm lamp does not 
light. 
* If the alarm lamp comes on again, contact the supplier for servicing 
(In case the fan is locked, the output from the transformer will be stopped as well.   
However, if it is caused by a jammed object, the fan will be repeatedly re-activated.)