15
■
Overview
Features
Lightweight and bar type with slim form factor
16.4mm x 22.4mm Cross-sectional shape, bar form. Fits into narrow area.
High power type (Effective neutralizing current > 1.6
μ
A
／
cm)
Made for high voltage power supply GP-1, which has safety functions.
Direct coupling type, effective neutralizing current > 1.6
μA
/ cm with alternative high voltage
charging (50 – 60 Hz, non-explosion-proof), decay time from
±
1000 V to
±
100 V within 2
seconds (100mm distance). Maximum 2 electrodes (HPB series or the other VESSEL
high-power brand electrodes) can be connected into one GP-1.
Short needle interval 15mm
Total length of bar can be ordered to fit to the size of object to be cleaned. Especially effective
for neutralize in closer distance without air purging.
Durable Titanium electrode needles
Electrode needles are made of titanium for longer lifetime / better Total Cost of Ownership.
Double protections for needle lost
A tapered pitch block cover fits over an electrode needle and stepped form of electrode bites
inner silicone cable sheath. Those form factor pretend electrode from falling down which will
cause critical results.
Shielded cable
The cabling from high voltage power source to electrode is shielded to realize high noise
protection and very low leaking to metal machine frames. Shielding material is connected to
earthing plate therefore grounding is complicated by connecting only at power source side.
Back-stud bolt on the back side
2- 4 of back-stud bolts are pre-installed. Pitch and interval can be custom ordered.
High quality air assist bar (option)
An air pipe for compressed air to increase distance from object materials can be ordered as
option. This brass air assist bar was polished not only outer but also inside to eliminate blowing
off metal particle produced from burrs or cutting / drilling dust. All holes are drilled fit to electrode
needle to increase efficiency of compressed air.
