27
Installation
Installation Area
⚠
WARNING
Prohibited
Do not use this product in the following areas. Otherwise, there is a risk of an
explosion or fire.
·
Environments that require anti-explosion measures.
·
Areas where corrosive gases or flammable or explosive gases are used.
⚠
CAUTION
●
Remember
Take into consideration the conditions surrounding the installation area.
·
Install the unit in an indoor location, not exposed to wind, rain, or direct
sunlight.
·
Do not install the unit where it may be exposed to water, oil, chemicals, etc.
·
Do not install the unit where it may be exposed to marked vibrations or shock
·
The temperature range should be 5°C to 40°C. Use the unit in a humidity
range of 35 to 65%.
●
Remember
Do not use this product where it will be directly exposed to high temperatures or
high humidity. Doing so could cause the burn or breakdown of motor.
Installation Area
Install the unit in an indoor location not exposed to wind, rain, or direct sunlight.
Avoid using the unit in areas where water, oil, or dew condensation will get on it or where there will
be sudden temperature changes.
Avoid using the unit where it will be exposed to strong vibration or impacts.
This unit has an exhaust outlet on the backside, bottom of the unit.
Install this unit so that the exhaust outlet is 10 cm or more away from the wall, etc. because the normal
exhaust function will be impaired, causing a decrease in the dust collection capability, if the unit is
installed with the back of the unit against a wall, etc.
Ambient temperature and humidity
Use in a temperature range of 5 °C to 40 °C. Use the unit in a humidity range of 35 to 65%.
Atmosphere
Do not operate the unit in environments where anti-explosion measures are required.
Do not operate the unit in areas where corrosive gases or flammable or explosive gases are used.
In addition, use the unit in a well ventilated area with a normal air atmosphere.
Input voltage and compressed air
This unit uses 24V DC input voltage and 0.1 MPa to 0.6 MPa compressed air for the cleaning air.
Install the unit where it can be connected to wiring and piping that meet these specifications.
Maintenance space
Space for maintenance and inspections should be maintained around the unit.
In particular, the space in front of the unit required for daily maintenance should be obtained.
Summary of Contents for IPC-A4
Page 6: ...6 外観図 外観図 ...
Page 26: ...26 External View ...
