Safety precautions
·
Please note, that the
Vestamatic
Markise Plus 500 V 2.0
sunshade control
requires an operating voltage of 230 V
W
, 50 Hz. Make sure to contact a profes-
sional electrician for the installation as well as for the setting of the DIP switches
on the rear panel of the device.
·
Make sure to turn off the operating voltage before working on sunshade drives or
shading that are driven by
Vestamatic
Markise Plus 500 V 2.0
sunshade
control
.
·
The control was designed for correct use as described in the operating instruc-
tions. Any changes or modifications thereof are not permissible and will result in
loss of all warranty claims.
·
Check the
Vestamatic
Markise Plus 500 V 2.0
sunshade control for any
signs of mechanical damage immediately after unpacking. If there is damage due
to the shipping, please notify the supplier immediately.
Do not start up the control in case there is any damage!
·
If safe operation of control, drives or shading can not be guaranteed, the
Vestamatic
Markise Plus 500 V 2.0
sunshade control must be turned off
immediately and protected against unintentional operation.
G
-
29 -
Introduction
Congratulations for buying the
Vestamatic
Markise Plus 500 V 2.0
sunshade control. You have purchased a high-quality product that fea-
tures many practical programming options and has been manufac-
tured according to the highest quality standards which will guarantee
optimum efficiency and reliability. Please take the time to read these
operating instructions carefully before starting up.
The minimum delivery extent of the
Vestamatic
Markise Plus 500 V 2.0
sunshade control
includes the following items:
1. Cover cap
2. Basic housing
3. Supporting frame basic housing
4. Adjustment tool
5. Combination frame one-fold – Jung “CD 500”, alpine-white
G
-
30 -
