Programming the radio transmitter
In order to start up the radio transmitter, you must assign it to the
Vestamatic
VestaFunk MS 16.
For each button to be programmed, the
operating voltage must be switched on individually.
Please perform the following steps:
Programming a radio transmitter
·
Switch on the operating voltage of the
Vestamatic
VestaFunk MS 16.
·
Wait for 1 second until the red LED on the front side of the device
is flashing.
·
Press the button to be programmed for 1 second. Repeat the
above steps for all other buttons to be programmed.
Deleting a radio transmitter
·
Press the retract button of a remote control which is programmed
already and keep it pressed.
·
Switch on the operating voltage of the
Vestamatic
VestaFunk MS 16.
G
- 27 -
Programming the radio transmitter
·
Wait for 1 second until the red LED on the front side of the device
is flashing.
·
Press the button to be deleted for 1 second. Repeat the above
steps for all other buttons to be deleted.
Deleting all stored radio transmitters
·
Press the extend button of the remote control to be programmed
and keep it pressed.
·
Switch on the operating voltage of the
Vestamatic
VestaFunk MS 16.
·
Wait for 1 second until the red LED on the front side of the device
is flashing.
·
Release the extend button of the remote control.
G
- 28 -
83201911 H1.qxd 04.04.01 11:20 Seite 27
