English
- 26 -
Installing the Batteries to the Remote
1.
Lift the cover on the back of the remote upward
gently.
2.
Install two AAA batteries. Make sure to match the +
and - ends of the batteries in the battery compartment
(observe the correct polarity.
3.
Replace the cover.
Connect Power & Antenna/Cable/
Satellite
IMPORTANT
:
The TV set is designed to operate on
220-240V AC, 50 Hz socket.
After unpacking, allow
the TV set to reach the ambient room temperature
before you connect the set to the mains. Plug the
power cable to the mains socket outlet.
SPDIF
VGA
Aerial
or
Cable
Satellite
DiSEqC
Switch
F connector
13V dc /18V dc
3
If there is an F connector supplied with your TV, you
should use it while connecting the sattellite LNB cable.
(As illustrated above) (Optional).
Switching On/Off
To Switch the TV On
Connect the power cord to the 220-240V AC, 50 Hz.
Press button. Then the standby LED lights up.
To switch on the TV from standby mode either:
Press the “ ” button,
CH ^/ v
or a numeric button on
the remote control.
To Switch the TV Off
Press the “ ” button on the remote control or press
the button or hold the control switch on the Tv
until shut down, so the TV will switch to standby mode.
(Depends model)
To power down the TV completely, unplug the power
cord from the mains socket.
Note
: When the TV is switched to standby mode, standby LED
can blink to indicate that features such as Standby Search, Over
Air Download or Timer is active. The LED can also blink when
you switch on the TV from standby mode.
First Time Installation
When turned on for the first time, the “language
selection” menu appears. The message “
Welcome
please select your language!
” is displayed in all
language options listed alphabetically.
Press the “
” or “
” button to highlight the
required language, press
OK
button to select. “First
Time Installation” appears. Use “ ” or “ ” button to
set the required country, and press “
” button to
select Search Type (optional).
Use “ ” or “ ” to set the desired search type. Available
search types are Digital and analog, digital only and
analog only.
When set, press “
” to select Teletext Language.
Use “ ” or “ ” to select the desired Teletext Language.
Next, select
Scan Encrypted
and set as
Yes
if you
want to scan coded stations.
Press
OK
button on the remote control to continue
and the following message will be displayed on the
screen.
Summary of Contents for 39PF5025
Page 1: ...VESTEL TELEViZYON KULLANIM KILAVUZU OPERATING INSTRUCTIONS SATELLITE 42PF5040 42 LCD TV...
Page 42: ......
Page 43: ......
