English
- 16 -
No Signal Delay
Sets a delay value to the ‘No Signal’ preferences when the Display is in No Signal state.
After the set delay time is expired ‘No Signal’ preferences will be applied.
No signal Power
off
When enabled the Display will turn itself off after a period of 5 minutes, if no signal is
received from the selected source.
This feature will only work if all of the following circumstances occur:
-
No Signal
option is set as
Failover
.
- USB device is not connected to the Display / USB device is connected but there are
no playable files installed in the USB device.
Panel Lock
Set as
Off
to prohibit the use of the buttons on the Display.
RCU Inhibit
Set as
On
to inhibit the use of the remote. Remote control will function in Stand-By
mode independently from the setting of this option.
To turn this option off and be able to use the remote again, press
MENU/M-1-9-7-3
buttons on the remote consecutively.
Signage Settings
menu will appear. Enter the
Controls
menu and set this option as
Off
.
UART 0
Select ASCII/HEX protocol for UART 0. Default value is ASCII. There is no need to
restart the Display after selection in order to work with the protocols correctly. If the
selection is changed, the latest selected protocol will be preserved and started when
the Display is booted up.
Note that ASCII/HEX selection is not working while debug logs are enabled. If it is
wrongly changed to HEX while debug logs are enabled, revert the selection to ASCII and
reboot the Display in order to correct the debug logs and the ASCII protocol behaviour.
Also note that HEX protocol will work with the baud rate value 19200 for UART0
UART 1
Select ASCII/HEX protocol for UART 1. Default value is HEX. There is no need to
restart the Display after selection in order to work with the protocols correctly. If the
selection is changed, the latest selected protocol will be preserved and started when
the Display is booted up.
Note that ASCII/HEX selection is always working as expected. It does not matter if the
debug logs are enabled or not.
Also note that HEX protocol will work with the baud rate value 9600 for UART1
Embedded Touch
Enables or disables the functionality of the embedded touch screen.
Power Up Settings
Power Up Mode
Configures the power up mode preference.
Last State, Always On
and
Standby
options are available.
Quick Standy
If this feature is enabled the Display can be turned on again
with the RS232 and Lan
commands
if it is turned off through it. Press
Left
or
Right
button to enable or disable
the feature.
Power on Delay
Sets a delay value at power on. This value can be set from 0 to 2000 ms in steps of 100
ms. The Display will turn on after the set delay time is expired.
Auto Launch
Configures the auto launch preference.
CMS(Start url)
,
Open Browser(Open Browser
initial page)
and
Disabled
options are available.
Boot Up Picture
Mode
Configures the picture mode preference at power on. If set as
Off
the last set picture
mode will be used at power on.
HDMI1 Wake Up
Enabled
If this option is set as
Enabled
, the Display will turn on with the HDMI input source,
when it is switched on. This feature works based on HDMI 5V signal. When this signal
is active the Display wakes up and when the signal is inactive the Display shuts down.
You can disable this option by setting as
Disabled
.
If any Scheduler is set or an OPS unit is connected to the Display, this option will be
inactive and can not be set as
Enabled
.
Note:
This feature may not be available depending on the model of your unit.
USB
Clone to USB
Copies the database files from the unit to a connected USB device.
Clone from USB
Copies the database files from a connected USB device to the unit.
