18
GB
To display target set point; in programming mode it
selects a parameter or confirm an operation.
To enter fast access menu
In programming mode it browses the parameter codes or
increases the displayed value. (DOWN); n programming mode
I
n programming mode it browses the parameter
codes or decreases the displayed value.
Push it for 3s to start a manual defrost
Export data from button
To switch off the light in the door
(only models with light in the door
Log activation and deactivation from button (Password
protected)
Bottons
DATA
How to see and modify the setpoint
How to: See the Set point
1. Push and immediately release the SET key: the display will show
the Set point value.
2. Push and immediately release the SET key or wait for 60 sec to
display the temperature in the unit
How to: Change the Set point
1. Push the SET key more than 2 sec to change the Set point value.
2. The value of the set point will be displayed and the “°C” LED will
start blinking.
3. To change the Set value push the UP or DOWN arrows within 60
sec.
4. To save the new set point value, push the SET key again and wait
for 3 sec.
NOTE:
To exit without making any change to the set point, push the
SET key or wait 60 sec.
REC
SET
