5
GB
Starting and cleaning
Before using the appliance, it is advisable to
wash down the inside with lukewarm water
and a mild detergent, and then to dry it off
thoroughly.
The temperature in the appliance will de-
pend on:
● The temperature in the room.
● The frequency and duration of periods
when the lid is open.
● The amount of goods.
It may therefore be necessary to change
the thermostat setting from time to time.
The outer mantle may get warm, but the
temperature will get lower when the goods
have attained the wanted temperature.
Before use
Please read these instructions carefully.
They will give you important information on
the installation, operation and maintenance
of the appliance.
If you throw out an old appliance, it is
important to destroy the locking mechanism
(not all models).
Damaged appliances must not be con-
nected to the mains. If doubts, ask your
supplier.
Placing
It is best to place the appliance in a dry
room with good air circulation. The room
temperature should be as low as possible
(energy-saving), but not lower than +5°C.
When placing the appliance, it must not
be exposed to direct sunlight or placed up
against a heat source.
The appliance must be placed on an even,
horizontal and stable surface.
Electrical connection
Wiring and connections in power supply
systems must been all applicable (local and
national) electrical codes. Consult these
codes lengths and sizes prior to cabinet
installation.
This device complies with relevant EU
directives including Low Voltage Directive
2014/35/EU and Electromagnetic Compat-
ibility Directive 2014/30/EU
The socket should be freely accessible.
Connect the appliance only to 220/240 V
/ 50Hz alternating current via a correctly
installed earthed socket.
The socket must be fused with a 10-13 A
fuse.
If the appliance is to be operated in a non-
European country, check on the rating plate
whether the indicated voltage and current
type correspond to the values of your mains
supply.
Information regarding voltage, current or
power are given on the rating plate
The power cord may be replaced by a
technician only.
The rating plate provides various techni-
cal information as well as type and serial
number.
Cleaning
Before beginning cleaning, switch off main
power at the wall socket. Clean the ap-
pliance with a mild soap solution. Use a
wrung-out cloth or sponge. Always dry off
with a clean, dry cloth. Warning: Never
use cleaning agents con-taining abrasive
substances.