-7-
7
GB
The door(s) can be changed from right-hinged to left-hinged and vice versa as follows:
Reversing the door(s)
1. Lay the appliance on its back with the
doors uppermost.
9. Remove the lower hinge. Rotate the
hinge through 180° and refit it on the
opposite side of the appliance.
10. Refit the kick plate
2. Remove the upper hinge.
3. Move the plastic plugs to where the
upper hinge was fitted.
4. Lift off the upper door and lay it aside.
11. Remove the door-closer and refit it on
the opposite side.
7. Remove the kick plate by pulling it
outwards and upwards.
12. Remember to pull the pin in the door
closer towards the side before fitting
the door.
5. Remove the middle hinge by
unscrewing the screws.
6. Lift off the lower door and lay it aside.
8. Loosen lock nut with the fork wrench
enclosed and move the pin.
15. Remove the door handles and refit
them on the opposite side.
Refit the caps.
16. The appliance must be allowed to
stabilise in an upright position for at
least 1 hour before being switched on.
17. After reversing the door(s), it is
important to check that the sealing
strip provides a tight seal all the way
round.
If it does not, carefully heat the strip
all the way round using a hair dryer.
Then ease the strip outwards slightly
so that it forms a tight seal against
the cabinet. Be careful not to heat the
strip so much that it melts!
13. Fit the upper door.
14. Fit the upper hinge.
7
GB
The door(s) can be changed from right-hinged to left-hinged and vice versa as follows:
Reversing the door(s)
1. Lay the appliance on its back with the
doors uppermost.
9. Remove the lower hinge. Rotate the
hinge through 180° and refit it on the
opposite side of the appliance.
10. Refit the kick plate
2. Remove the upper hinge.
3. Move the plastic plugs to where the
upper hinge was fitted.
4. Lift off the upper door and lay it aside.
11. Remove the door-closer and refit it on
the opposite side.
7. Remove the kick plate by pulling it
outwards and upwards.
12. Remember to pull the pin in the door
closer towards the side before fitting
the door.
5. Remove the middle hinge by
unscrewing the screws.
6. Lift off the lower door and lay it aside.
8. Loosen lock nut with the fork wrench
enclosed and move the pin.
15. Remove the door handles and refit
them on the opposite side.
Refit the caps.
16. The appliance must be allowed to
stabilise in an upright position for at
least 1 hour before being switched on.
17. After reversing the door(s), it is
important to check that the sealing
strip provides a tight seal all the way
round.
If it does not, carefully heat the strip
all the way round using a hair dryer.
Then ease the strip outwards slightly
so that it forms a tight seal against
the cabinet. Be careful not to heat the
strip so much that it melts!
13. Fit the upper door.
14. Fit the upper hinge.
