EN - 15
EN
5.1 Defrosting
Freezer defrosting process
WARNING:
Never use sharp metal
tools, unless recommended by the
manufacturer, for this operation as they can
damage the refrigeration circuit.
After some time, frost will build up in certain
areas of the freezer. The frost accumulated
in the freezer should be removed regularly
(use the plastic scraper if available).
Complete defrosting will become necessary
if the frost layer exceeds 3 - 5 mm in order
to maintain the efficiency of the freezer.
• It is recommended, the day before you
defrost, to set the thermostat dial to
position “5” to freeze the food completely.
• During defrosting, frozen food should be
wrapped in several layers of paper and
kept in a cool place. The inevitable rise
in temperature will shorten their storage
life. Remember to use this food within a
relatively short period of time.
• Set the thermostat knob to position “•”
and switch off the appliance.
• Leave the door open to accelerate
defrosting. Remove any water from the
compartment.
If there is water on the freezer floor, you
can remove it using a sponge.
• Clean the interior by hand with lukewarm
water and a little detergent.
• Never use abrasive products or
aggressive cleaning agents.
• Dry the inside of the unit, connect it to
the mains and set the thermostat knob
to position “5”. After 24 hours, reset the
thermostat to the desired position.
6 SHIPMENT AND
REPOSITIONING
6.1 Transportation and Changing
Positioning
• The original packaging and foam may be
kept for re-transportation (optional).
• Fasten your appliance with thick
packaging, bands or strong cords and
follow the instructions for transportation
on the packaging.
•
Remove all movable parts or fix them
into the appliance against shocks
using bands when re-positioning or
transporting.
Always carry your appliance in the
upright position.
7 BEFORE CALLING AFTER-
SALES SERVICE
If you are experiencing a problem with
your
appliance
, please check the following
before contacting the after-sales service.
Your appliance is not operating
Check if:
• There is power
• The plug is correctly placed in the socket
• The plug fuse or the mains fuse has
blown
• The socket is defective. To check this,
plug another working appliance into the
same socket.
The appliance performs poorly
Check if:
• The appliance is overloaded
• The appliance door is closed properly
• There is any dust on the condenser
• There is enough space near the rear and
side walls.
Summary of Contents for VR-BS16501M0
Page 27: ...PL 27 PL 2 1 Wymiary 600 mm min 550 mm 820 890 mm 595 mm 548 mm 812 882 mm 100 170 mm ...
Page 60: ...SK 60 SK 2 1 Rozmery 600 mm min 550 mm 820 890 mm 595 mm 548 mm 812 882 mm 100 170 mm ...
Page 76: ...SL 76 SL 2 1 Dimenzije 600 mm min 550 mm 820 890 mm 595 mm 548 mm 812 882 mm 100 170 mm ...
Page 84: ......
