Rev. 6/16/2020
BOL-G MANUAL
Copyright 2020 Vestil Manufacturing Corp. Page 2 of 5
SIGNAL WORDS
This manual uses SIGNAL WORDS to draw attention to uses of the product that could result
in personal injuries, as well as the probable seriousness of those injuries. Other signal words call
attention to uses likely to cause property damage. Signal words used in this manual appear below
along with their definitions.
Identifies a hazardous situation which, if not avoided, WILL result in
DEATH or SERIOUS INJURY. Use of this signal word is limited to the most
extreme situations.
Identifies a hazardous situation which, if not avoided, COULD result in
DEATH or SERIOUS INJURY.
Indicates a hazardous situation which, if not avoided, COULD result in
MINOR or MODERATE injury.
Identifies practices likely to result in product/property damage, such as operation
that might damage the product.
SAFETY INSTRUCTIONS
Vestil strives to identify all foreseeable hazards associated with the use of its products.
However, material handling is dangerous and no manual can address every conceivable risk.
Ultimately, the most effective way to prevent injury is to apply sound judgment whenever using this
device.
Improper or careless use of this product could result in death or serious personal injuries.
•
Read and understand the entire manual before assembling, installing, using or servicing the
product.
•
Read the manual to refresh your understanding of proper use and maintenance procedures.
•
DO NOT attempt to resolve any problem(s) with the product unless you are both authorized to do so and
certain
that it will be safe to use afterwards.
•
DO NOT modify the product in any way UNLESS you first obtain written approval from Vestil.
Unauthorized modifications automatically void the
unsafe to use.
•
Inspect the product at least once per month. DO NOT use this product if the inspection reveals structural
damage. Examples of structural damage include, but are not limited to, the following: 1) Cracked, broken, or
otherwise damaged welds; 2) Missing or obscured reflective tape (see item no. 3 on p. 3) or weak reflectivity
of reflective tape (item no. 3 on
); 4) Corrosion, severe wear, or other condition that compromises the
integrity of the bollard. Replace each part that fails to pass an inspection. DO NOT use the product until it is
fully restored to satisfactory condition. See
RECORD OF SATISFACTORY CONDITION
•
DO NOT use the product if it is not securely anchored to the ground/surface. The bollard should not
wobble. Relocate the bollard if it cannot be securely anchored to the ground/surface.
•
Replace the bollard immediately after it sustains damage. NOTE: Damaged sustained as a result of the
bollard’s intended/designed use is not covered by the warranty.
•
DO NOT use this device UNLESS all labels (see
) are clearly visible and
undamaged. Replace damaged labels as soon as damage occurs.
Proper use, maintenance, and storage are essential for this product to function properly.
o
Always use this product in accordance with the instructions in this manual and consistent with any training
relevant to machines, devices, etc. used in conjunction with this product.
o
Keep the product clean & dry. Lubricate moving parts.
