Rev. 2/27/2020
CARPET-D MANUAL
Copyright 2019 Vestil Manufacturing Corp.
Page 3 of 5
EXPLODED VIEW AND BILL OF MATERIALS
USING THE CARPET TRUCK
1.
Center the roll of carpet on the truck. Do not load
the truck beyond its capacity (500 pounds; 227.3kg).
If a carpet roll weighs more than 500 pounds, use
another device to move it. The end/edge of the
carpet should be on top of the roll.
2.
Retract both leg sets. Each leg set is fixed in the
extended or retracted position by a spring pin. Grasp
the wire ring and pull the spring pin out of the pin
hole of the leg bracket. Push the leg set towards the
frame and release the spring pin. The pin should seat
into the semicircular hole in the leg bracket.
3.
Grasp an end of the roll and carefully push the truck.
Do not traverse sloped ground with a loaded truck
unless you can easily control it. Always remain uphill
from the truck. If you cannot push or control the
truck when it is loaded, enlist a coworker to assist
you. Both persons should grasp the same end of the
roll and push the truck wherever needed.
Item
Part no.
Description
Qty. Item
Part no.
Description
Qty.
1
33-001-157 Frame, assembly
1
7
33-017-045 Bar, stiffener, roller
2
2
33-516-009 Weldment, mount bracket
2
8
33-527-001 Assembly, roller
2
3
33-514-165 Weldment, stand
2
9
65125
Cotter pin, zinc plated,
3
/
16
” x 1
1
/
2
”
4
4
11057
Hex bolt, gr. A, zinc plated,
5
/
16
”-18x1
4
10
33006
Flat washer, zinc plated,
USS,
5
/
16
”
4
5
37021
Nylon insert lock nut, gr. 2, zinc
finish,
5
/
16
”-18
8
11
11055
Hex bolt, gr. A, zinc
plated,
5
/
16
”-18 x 1”
4
6
33-016-075 Bracket, mount, roller, formed
4
12
42011
U-bolt,
1
/
4
”-20 x
3
/
4
”
4
13
37018
Nylon lock nut, gr. 2, zinc
finish,
1
/
4
”-20
8
Center the roll
on the truck
Pull ring to
disengage
spring pin
Semicircular hole
in leg bracket
