Rev. 10.24.2019
LAD-PW, MANUAL
Copyright 2019 Vestil Manufacturing Co.
Page 18 of 23
[2-5 step models] Step 4:
Install the plugs, caps, and wheels.
a) Install the plastic plugs and square caps in the leg tubes. First, press the 1in. plastic plug into the
leg tubes. Then, press the square caps over the plugs and onto the legs. If necessary, use a rubber
mallet to gently tap the plugs and caps into place.
b) Apply a permanent thread bonding and sealing compound like Loctite® Threadlocker Red 271™ to
the threads of the locking stem casters (16-132-163). Wind the stems into the rear legs. Follow the
directions provided with the thread compound.
Caster
16-132-163
1in. x 1in.
square cap
1in. black
plastic plug
A
A
Apply permanent locking
and sealing compound
to threads
[
LAD-PW-26-11-G, LAD-PW-26-11-P, LAD-PW-26-12-G, & LAD_PW-26-12-P]
Step 3:
Install the outriggers. Align the
bolt hole in each outrigger with the bolt hole in the support bracket (circled). Put 1 flat washer (33006) on
a bolt (11055). Insert the bolt (11055) through the outrigger, the support bracket, and base support.
Secure the bolt with a lock nut (37021). Repeat this process with the other outrigger. Tighten the
connections.
44-514-311
Left
outrigger
11055
44-514-310
Right outrigger
37021
Support
bracket
Base
support
Press down on
brake lever to
lock caster. Lift
lever to release
brake
Return to
Brake lever