Rev. 10.24.2019
LAD-PW, MANUAL
Copyright 2019 Vestil Manufacturing Co.
Page 22 of 23
LABELING DIAGRAM
Each unit should be labeled as shown in the diagram. Label content and location are subject to change so your
product might not be labeled exactly as shown. Compare the diagram below to your
. If there are any differences between actual labeling and this diagram, contact
Replace all labels that are damaged, missing, or not easily readable (e.g. faded). To order replacement labels
or to inquire whether your unit is properly labeled, contact the technical service and parts department online at
http://www.vestilmfg.com/parts_info.htm
or by calling (260) 665-7586 and asking for the Parts Department.
D: Label 287 (on nosing of a step)
B: Label 904 (on
nosing of a step)
A: Label 740 (on nosing of a step or platform)
C: Label 821 (on nosing of a step)
A
B
C
D
NOTE:
To provide access to this manual for all persons who use this ladder, a protected copy of the
manual should be attached to the ladder. For example, a copy of the manual can be placed inside a
transparent plastic pouch or folder that is tied to the ladder frame. An appropriate place to tie the folder to
the frame is on the side rail next to the step where label 821 is applied
.
