Rev. 5.24.2022
LAD-RAF, MANUAL
Copyright 2022 Vestil Manufacturing
Page 15 of 19
Step 3: Install the plugs, caps, axle and wheels.
a)
Install the plastic plugs and square caps in the front legs. First, press the 1in. plastic plug into the
front legs. Then, press the square caps over the plugs and onto the ends of the legs. If necessary,
use a rubber mallet to gently tap the plugs and caps into place.
b)
Insert the axle through the axle receiver of the back leg weldment.
c)
Then, slide the wheels onto the ends of the axle. Secure the wheels to the axle by inserting a cotter
pin through the pinhole in each end of the axle. Periodically lubricate the axle to allow the wheels
to rotate freely.
Step 4 (LAD-R-26-11 & LAD-R-26-12 only): Install the outriggers.
1in. black
plastic plug
Outrigger
5
/
16
in. - 18
lock nut
5
/
16
in. – 18 x 1in. bolt
Outriggers
installed
Ladder
assembly
Axle
Axle
receiver
Axle
Cotter pin
(bend the ends of
the cotter pins
around the axle)
1in. x 1in.
square cap
