Table of Contents
Rev. 3.19.2020
LAD-TRS MANUAL
Table of Contents
Copyright 2020 Vestil Manufacturing Co.
Page 9 of 13
Step 3: Install the plugs, caps, and wheels.
a) Install the plastic plugs and square caps in the
leg tubes. First, press the 1in. plastic plug into
the leg tubes. Then, press the square caps over
the plugs and onto the ends of the legs. If
necessary, use a rubber mallet to gently tap the
plugs and caps into place.
b) Press a plug into each end of the cross brace.
Step 5: Attach the handrails to the side rails of the ladder assembly with
5
/
16
”–18 x 1
3
/
4
” bolts (11060) and
5
/
16
” – 18
lock nuts (37021).
Ladder
assembly
1”x1”
square cap
99-024-027
Insert plug
99-025-025
Cross
brace
Handrail
11060
37021
1” black
plastic plug
99-025-025
1.5”x1.5”
square cap
99-024-028
1.5” black
plastic plug
21-024-016
Step 4: Fasten the wheel brackets (44-514-313; “caster
tilter frames” in exploded views) to the ladder assembly
with
5
/
16
”-18 x 1
3
/
4
” bolts (11060) and lock nuts (37021).
Attach the wheels (16-132-009) to the wheel bracket as
indicated in the diagrams below.
44-514-313
11060 & 37021
16-132-009
11113 + 37024
