Rev. 7/14/2016
PMPS, MANUAL
Copyright 2016 Vestil Manufacturing Corp.
Page 12 of 22
Loading instructions:
The capacity of this PMPS-series lifter is 4,000 lb.
Every unit is labeled with this information (see label 287
on p. 20). DO NOT attempt to lift loads that exceed the
capacity! Personal injury or permanent damage to the
lifter might occur.
When loading the PMPS, always follow these
guidelines:
1. The load should firmly contact the heels of the forks
2. DO NOT apply a load to the tips of the forks
3. Center the load on the forks
4. Only transport loads in the lowered position
5. Apply the floor lock
and
both caster brakes (only
one caster shown in diagram at right) whenever
the lifter is not in use. They should also be applied
anytime a load is being elevated. To apply the
floor lock, press down on the lock lever. Apply the
caster brakes by pressing down the brake lever
until the brake firmly contacts the top of the wheel.
RESPONSIBILITIES OF OWNERS & USERS:
1.) Inspect and maintain this product in accordance with this manual (see “Inspections & Maintenance; p. 18). ONLY
use the pallet handler if it is in normal operating condition.
2.) ONLY use this device after you read and understand all operating procedures and safe use recommendations
provided in this Owner's Manual.
3.) Lifter must never be overloaded.
FIG. 8: 115VAC modular power unit layout
Lock lever
Floor
lock
Brake
contacts
top of
wheel
Caster
brake
Brake
lever
