background image

TABLE OF CONTENTS

 

Rev. 7/16/2021 

   SPS3 MANUAL 

TABLE OF CONTENTS

 

COPYRIGHT 2021 VESTIL MANUFACTURING CO.                                               PAGE 2 OF 7 

SIGNAL WORDS  

  This manual uses SIGNAL WORDS to indicate the likelihood of personal injuries, as well as the probable 

seriousness of those injuries, if the product is misused in the ways described. Other signal words call attention 

to uses of the product likely cause property damage. The following are signal words used in this manual and 

their definitions.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

SAFETY INSTRUCTIONS 

 

Vestil strives to identify foreseeable hazards associated with the use of its products. However, no 

manual can address every conceivable risk. To minimize the likelihood of being injured as a result of using 

this device, inspect and maintain the product as instructed in 

INSPECTIONS & MAINTNENANCE and

 exercise 

sound judgment whenever using this device. 

 

 

 WARNING 

Risks of serious personal injuries or death.  

 

Read this manual in its entirety before assembling, using, inspecting or servicing the product

Read the 

manual to refresh your understanding of use, inspection, and maintenance procedures as necessary. A 

copy of this manual should always be available to all persons who assemble, use, inspect and/or maintain 

this device.  

 

DO NOT exceed the capacity. Capacity figures are provided on label 446, which is shown in 

LABELING DIAGRAM

 on p. 6.

 

o

 

Overall capacity of the cart is 1000 pounds (454.5kg). 

o

 

Each shelf has a capacity of 550 pounds (250kg).  Although  SPS3-series carts have  3 

shelves, no more than 1,000 pounds in total can be applied to them. 

o

 

The capacity of the step assembly is 350 pounds (159kg). 

 

All items loaded on the cart must fit within the shelves. Loads must not hang over the shelves. 

Only use the cart to transport stable, evenly distributed, non-hazardous loads. 

 

Use this cart ONLY on even, level surfaces. 

 

DO NOT climb the steps unless both caster brakes are firmly engaged and all 4 rubber feet are 

in satisfactory condition. See applicable 

EXPLODED 

VIEW

 on p. 3. 

 

DO NOT modify the product in any way UNLESS you first obtain written approval from Vestil. 

Unapproved modifications automatically void the Limited Warranty and might make the product 

unsafe to use. 

 

DO NOT use this device UNLESS all product labels are readable and undamaged. Se

LABELING 

DIAGRAM 

on p. 6. 

 

Inspect the product before each use. Do not use it unless it is in 

SATISFACTORY CONDITION

. See 

RECORD OF SATISFACTORY CONDITION

 an

INSPECTIONS & MAINTENANCE

 on p. 6. 

 

Always properly load the cart: 

o

 

If the load might roll or slide off of the deck, strap it to the deck before moving the cart. 

o

 

Evenly distribute loads on the shelves. DO NOT concentrate loads on the sides.  

o

 

Load the bottom shelf first; then load the top shelf. Label 446 in the 

LABELING DIAGRAM

 

indicates the capacity per shelf as well as the total capacity of the cart. 

 

 Proper maintenance and storage are essential for this product to function properly. 

o

 

Apply the 

INSPECTION AND MAINTENANCE

 instructions on p. 6 of this manual.  

o

 

Keep the product clean & dry. Always store it inside. 

     DANGER

 

Identifies a hazardous situation which, if not avoided, WILL  result in DEATH or 

SERIOUS INJURY.  Use of this signal word is limited to the most extreme situations

.

 

 

 

WARNING

 

Identifies a hazardous situation which, if not avoided, COULD result in DEATH or 

SERIOUS INJURY.

 

 

 

CAUTION

 

Indicates a hazardous situation  which, if not avoided, COULD result in MINOR or 

MODERATE injury.

 

 

 

NOTICE

 

Identifies practices likely to result in product/property damage, such as operation 

that might damage the product

.

 

 

Summary of Contents for SPS3 Series








Reviews: