Rev. 3/7/2022
VST-4-Y, MANUAL
Copyright 2021 Vestil Manufacturing Corp. Page 8 of 10
RECORD OF SATISFACTORY CONDITION (THE “RECORD”)
After the unit is assembled, make a detailed record of its condition. Include observations
about all features: all surfaces and the underside, handrails, feet, anti-slip tape, fasteners
(bolts, nuts, washers) and casters. Thoroughly photograph the unit from multiple angles so that
all features are clearly imaged. Photograph all labels applied to the product and all
information molded into the (yellow) plastic material. Collect all photographs and writings in a
single file. This file is a record of the product in satisfactory condition. Compare the results of
each inspection to this
RECORD
to determine if the unit is in satisfactory condition. Do not use
the product unless it is in satisfactory condition.
INSPECTIONS AND MAINTENANCE
Compare inspection results to the
. Do not continue to use the steps unless every
. Cosmetic changes, like damaged handrail
paint/powder coat, are not changes from satisfactory condition. However, touchup paint
should be applied to all affected areas as soon as damage occurs. Contact
to order replacement parts. Contact information is provided on the cover page of
this manual.
Inspect the following at least once per month:
1.
Step surfaces – Check all surfaces of the product for dirt or other matter, especially fluids.
Clean the steps. Look for cracks, rot, flaking, and other forms of damage. Pay particular
attention to the condition of the bottom edge. If the stepstool is cracked, remove it from
service.
2.
Handrails and fasteners – Examine both handrails & fasteners (bolts, nuts, & washers).
Replace damaged/worn hardware. The handrails must be solidly fastened to the stool. If a
lock nut is unfastened from its bolt, it must be replaced with a new lock nut.
3.
Molded rubber feet – Examine each foot for damage and significant wear. Do not use the
steps unless all 8 rubber feet are installed and in satisfactory condition.
4.
Casters – Inspect both casters for damage and significant wear. The casters must be solidly
attached to the back of the steps.
5.
Labels– Replace each label that is damaged, missing, or not easily readable.
6.
Anti-slip tape strips – There should be 3 strips of anti-slip tape applied to the step surface of
the first 3 steps. The top step should have 4 strips of tape. Make sure that anti-slip, abrasive
material is present along the entire length and width of each strip of tape. Tape strips
should not be peeling off of the steps.
