User Instruction for
the VIP- 884-KMV-TS Series "TouchMux"
Keyboard, Mouse, Video, and Touch Screen Multiplexer
FEDERAL COMMUNICATIONS COMMISSION
This equipment has been tested and found to comply with the limits of a Class A digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection against harmful interference when equipment is operated in
a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and
used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this
equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the
interference at their expense.
CE
This equipment has been tested and found to conform to the directives and standards for a Class A Information Technology
Equipment type and for the Commercial Light Industrial equipment class.
INTRODUCTION
The VIP-884-KMV-TS "TouchMux"
KVM Splitter/Multiplexer allows up to four workstations, each consisting of a keyboard,
PS/2 mouse and one monitor with touch screen capabilities to share local access to one PC. Please note that the monitors at
all workstations will be viewing the same image at all times.
INSTALLATION
Connection to the Splitter/Multiplexer to the PC must be made while the PC is powered down.
1. Connect PC to Multiplexer unit:
(a) Connect the PC’s keyboard port to the Splitter/Multiplexer using a PS/2 male/male (6 pin DIN) extension cable supplied
with the Splitter/Multiplexer. Make this connection from the PC's keyboard port to the Splitter/Multiplexer’s backpanel
connector marked "TO PC KBD". An adapter, the VIP-301-5M6F (may be purchased separately) will be needed for
connecting to an AT style PC.
(b) Connect the PC’s mouse port to the Splitter/Multiplexer using the second PS/2 male/male (6 pin DIN) extension cable
supplied with the Splitter/Multiplexer. Make this connection from the PC's mouse port to the Splitter/Multiplexer’s
backpanel connector marked "TO PC MSE".
(c) Connect the PC’s Video output to the Splitter/Multiplexer using a HDD15 male/female extension cable supplied with the
Splitter/Multiplexer. This connection is made from the PC's video output to the Splitter/Multiplexer’s backpanel connector
marked "TO PC VIDEO OUT".
(d) Connect the PC’s Touch Screen inputs to the Splitter/Multiplexer using a DB9 male/female extension cable supplied with
the Splitter/Multiplexer. Make this connection from the PC's touch screen input to the Splitter/Multiplexer’s backpanel
connector marked "TO PC TOUCHSCREEN".
2. Connect Workstations to the Multiplexer:
(a) Connect the keyboard of Workstation #1 to the Splitter/Multiplexer’s backpanel 6-pin DIN connector marked "STA-1
KBD". An adapter the VIP-301-5F6M (may be purchased separately) will be needed for connecting an AT style keyboard
to the MegaMux.
(b) Connect the PS/2 mouse of Workstation #1 to the Splitter/Multiplexer’s backpanel 6-pin DIN connector marked "STA-1
MSE".
(c) Connect the VGA monitor of Workstation #1 to the Splitter/Multiplexer’s backpanel 15-pin HDD connector marked
"STATION-1 MONITOR".
(d) Connect the Touch Screen portion of the VGA monitor of Workstation #1 to the Splitter/Multiplexer’s backpanel DB9
connector marked “STATION-1 TOUCHSCREEN.
275-J MARCUS BLVD HAUPPAUGE, NY 11787 USA
Tel: 631-434-3185 Fax: 631-434-3516
www.vetra.com email: sales@vetra.com
