Vetrano Espresso Machine
20
Not Heating
Verify the machine is plugged into the outlet and the outlet has power.
Make sure the power switch is in the “
II
” heating position and has been turned on for
at least 15 minutes.
Make sure the water is turned on to the machine. If the water was turned off, then
turn the water back on. Turn the power switch off, unplug the machine and then wait
5 seconds and then plug the machine back in and turn the power switch on.
Check the resettable hi-limit switch on the boiler.
Unplug the machine from the outlet and remove
the top of the machine. Locate the resettable
hi-limit switch on top of the boiler shown in the
picture to the right. Press the small center button
down firmly to reset. Then plug the machine back
in and turn on the power switch.
Espresso Coming Out Too Slow Or Not At All
Activate the brew lever and check the pump pressure. Recommended setting is 9
bar. Adjust pump pressure if necessary.
If pump pressure is good then try adjusting grind coarser.
Be sure the insert basket is not over filled with coffee and you are tamping with no
more than 30lbs of pressure.
Espresso Coming Out Too Fast
Activate the brew lever and check the pump pressure. Recommended setting is 9
bar. Adjust pump pressure if necessary.
If pump pressure is good then try adjusting grind finer.
Be sure the insert basket is filled with the proper amount of coffee and you are
tamping with 30lbs of pressure.