x
x
x
WIRELESS MODEL INSTALLATION
SPEED TRANSMITTER & MAGNET
The V100A is designed to operate as a wireless unit with the
installation of a special active mount and WL wireless speed
transmitter.
Step 1:
Step 2:
Step 3:
Step 4:
Step 5:
Step 6:
Use the zip-ties supplied to hold loosely the wireless
speed transmitter and mounting pad to the left fork leg.
Note:
To maximize signal reception, position the
transmitter as high up on the fork leg as possible. (Fig. 9)
Tighten the spoke magnet to any spoke on the
"transmitter side" of the front wheel so that it passes
over the alignment mark on the transmitter. (Fig. 9, 10)
Attach the alignment setup spacer to the magnet
temporarily. (Fig. 11 )
Slide and rotate the transmitter until the alignment mark just
touches the spacer tip on the magnet. (Fig. 12)
Snug the zip ties down to hold the transmitter in its final
position.
Remove the spacer and verify that the magnet and
transmitter spacing stayed the same. (Fig. 13)
NOTE:
WL2X Double wireless Speed & Cadence is optional.
Please refer to WIRED SPEED AND CADENCE/WL2X DOUBLE
