7. Press
FAN
to select fan speed. If no speed selected, “
nO
“
will be displayed instead temperature setpoint.
Press
PROG
and select next event.
For 24 hours 4 events can be setted.
If no buttons are pressed during 2 minutes, program menu will be switched OFF.
Temperature sensors data indication
1. Press
PROG
and after
SCREEN
to reach temperature sensors data display.
2. Press▲▼to select sensors, which are displayed instead time.
Sensors marking:
“J1“
– supply air temperature,°C
“J2“
– return water temperature,°C
“J3“
– outside air temperature,°C
“J4“
– extract air temperature,°C
“J5“
– exhaust air temperature,°C
“J6“
– extract air humidity, %
“J7“
–
heat exchanger efficiency by exhaust air temperature, %
“J8“
– room air temperature,°C
“J9“
– preheater temperature,°C
“J10“
– supply air humidity, %
“J11“
– outside air humidity, %
“J12“
–
supply air pressure, %, Pa/10
“J13“
– extract air pressure, %, Pa/10
“J14“
– CO
2
in extract air, %, ppm/10
“J15“
– heating, %
“J16“
– cooling, %
“J17“
– By pass, %
3. Press
POWER
, to leave indication mode.
If no buttons are pressed during 2 minutes, indication mode will be switched OFF.
Installation
1. Install connection cable between AHU and remote control.
Attention: blue connector is for remote control, modular connector is for AHU.
2. Open remote control and pass throught base part cable.
3. Fix base part to the wall.
4. Connect cable to remote control.
5. Close remote control.
