REAR LUGGAGE
RACK STRUT
TURNSIGNAL
STALK BOLT
LUGGAGE RACK
REAR
LUGGAGE
RACK
STRUT
6mm FLAT
WASHER
6mm x 30mm LOCK BOLT
Mount the rear luggage rack
strut and turnsignal stalks
to the tomahawks.
Mount the rear luggage rack
strut to the tomahawks in the
position shown (the holes in
the upper section of the strut
should line up with those in
the luggage rack) with the two
special turnsignal stalks bolts
and the two supplied turn-
signal stalks. Assemble the
parts in the order shown.
Special wiring note: To achieve
a good electrical ground, it is
suggested that you scratch the
surface of the rear luggage rack
strut and tomahawk where
the turnsignal stalk and bolt
contact them.
8
Mount luggage rack to
luggage rack rear strut
With 2-6mm x 30mm lock
bolts and 2-6mm flat washers,
mount the luggage rack to the
rear luggage rack strut.
Electrical hook-up
Run the wire of each turnsignal
( L-orange, R-blue) through its
stalk. Reverse the procedure
in steps 5, 4, 3, 2 and 1 under
Preparation for Hardware
Mounting. Before connecting
the wires together add the 7"
wire extensions. Match colors
and connect.
NOTE: Check turnsignals for
correct operation. Refer to
Troubleshooting, if not.
10
