2. Verifying the Product Name and Accessories
2．1
Motors, Drivers and Accessories
Check that the motor, driver and any accessories are all present. If an accessory is missing or damaged, contact the nearest
ORIENTAL MOTOR office.
・Motor .......................................................1 piece
・Signal Cable for externalspeed potentiometer
The O-rings are fitted in the pilot section of
(1m long) ..................................................1 piece
pinion shaft type motors.
・Set of mounting bolts
・Driver.......................................................1 piece
(provided only with combination types)
・Driver base mounting bracket .............2 pieces
M8 bolts ....................................................4 pieces
Driver back mounting bracket ..............1 piece
Nuts...........................................................4 pieces
Mounting screws ....................................4 pieces
Spriing washers .......................................4 pieces
・External speed potentiometer ...............1 piece
Washers ....................................................4 pieces
Variable resistor (20kΩ, 1/4W)
Key ............................................................1 piece
・Manual (This document) ..........................1 piece
3
Motors and Drivers have been designed and inspected according to the following standards.
Unit Model name is not the recognized name and the certified name under the various safety standards.
Recognized name and certified name are motor model name and driver name.
※
Application of EN standard for
FBL575SW-
□
type and
FBL5120SW-
□
type is pending.
Note
The EMC measurements required under standard EN50178 are not performed separately for motors and
drivers. Perform the EMC test when they are incorporated into the final product.
The over-voltage protection test required under standard EN50178 is not performed. Perform the test when
incorporated into the final product.
Standards
UL1004
CAN/CSA C22.2 No.100
EN60950
EN60034-1
EN60034-5
UL508C
CAN/CSA C22.2 No.14
EN60950
Motor
Driver
※
Certification Body
Standards File No.
UL
File No. E62327
DEMKO
Certificate No.124888/DK 98-03353
UL
File No. E171462
DEMKO
Certificate No.124886/DK 98-03350
CE Marking
Low Voltage
Directive
Installation Conditions
Overvoltage category
Ⅱ
, Pollution degree 2, Class
Ⅰ
（
For EN Standard
）
When the machinery to which the motor and driver are mounted requires
overvoltage category
Ⅲ
and pollution degree 3 specifications,
install the motor and driver in a cabinet that complies with IP54 and
connect to power supply via an isolation transformer.
