3．2
Driver Installation
(1) Driver Installation
The driver can be mounted on machinery using the mounting brackets provided.
■
Base mounting
■
Back mounting
■
Mounting dimensions
Base mounting
Back mounting
Note
・
When mounting the driver directly on a surface without using the mounting brackets, be sure to use screws of
suitable length. If the screws are too long, they could make contact with the driver's internal circuits and damage
the driver. (Use mounting screws that extend no further than 3mm from the surface of the driver into the driver.)
・
To improve ventilation, mount the driver in an upright position as shown in the figures above.
・
When mounting the driver in a tightly close up place like the control panel and a place where there is a heating
hearby , be sure to when the driver ambient timperature exceeds 40
℃
, cool the driver with a fan.
・
The back mount brackets are asymmetry up and down snd they can be used at any direction.
・
The size * in the diagram vary depending on the direction fo the mounting plate. In the reverse direction it is 19mm
long.
(2) Mounting Two or More Drivers
When mounting two or more drivers, separate them by a space
of at least 20mm. Leave at least 25mm between of space the
driver and other devices or structures.
25mm or more
(.98)
20mm or more
(.79)
Leave sufficient space for air to pass between the drivers.
7
130(5.12)
130(5.12)
69(2.72)
25(.98)
17(.67)max.
4-M4
10(.39)
19.5(.77)
45(1.77)
25(.98)
45(1.77)
150(5.91)
180(7.09)
200(7.87)
25(.98)
4.5(.18)
4-M4
＊
15(1.59)
