AUTOMIX 10 (EN) 0508
AUTOMIX 10
MOUNTING AND OPERATING INSTRUCTIONS
GENERAL FUNCTIONS
AUTOMIX 10 is an advanced electronic temperature control for hydronic radiator and radiant floor
heating systems. It can easily be integrated into an existing heating system. The main supply and all
sensors have plug-in connections. The quick do-it-your-self installation saves on labor charges.
AUTOMIX 10 works continuously and proportionally. Through impulses from the sensors the controller
directs the motor to keep the valve plug in the position that corresponds to the actual heat requirement
of the house.
DELIVERY PARTS OF ART.NO 1210
1. Valve motor AUTOMIX 10 with built-in electronics and mounting kit
2. Adapter 230/18 VAC 200 mA with 1,7 m wire
3. Supply water sensor T1 with 1 m wire
4. Outdoor sensor T2 with 15 m wire
OPTIONALS
5. Room sensor AUTOMIX 10RB with 15 m wire, art.no 1211
AUTOMIX 10RB should be installed if the room temperature of the house fluctuates because the building is
affected by e.g. sunlight or wind. With AUTOMIX 10 RB the room temperature can be set between 12°C and
27°C.
6. Remote control AUTOMIX 10RC with 15 m wire, art.no 1212
Remote control AUTOMIX 10RC is designed for floor heating systems. The remote control provides a
convenient way to adjust the supply water temperature without going to the boiler room.
MOUNTING
Supply water sensor T1
Supply water sensor T1 is fastened to a non-insulated part of the supply pipe after the mixing valve.
For optimum temperature measuring the pipe and sensor have to be insulated afterwards.
Outdoor sensor T2
Outdoor sensor T2 is to be mounted on the north or northwestern outside wall at least 3 metres above
ground. The outdoor sensor must never be mounted above a window or near an air valve as this
would influence the sensor.
Room sensor AUTOMIX 10RB
Room sensor AUTOMIX 10RB is mounted at a place with an average temperature of the house. The room
sensor should not be placed where it can be affected by direct sunlight, heat radiation or draught. Radiators
with a thermostatic valve in the same room as the room sensor must be max. opened to obtain a correct
temperature control.
Remote control AUTOMIX 10RC
Remote control AUTOMIX 10RC is mounted at a convenient place for operating.
