7
6
Installing board-to-
board audio cable
Step 1
Locate the audio pin header (JAUDIO1) on the EMIO-3110 module
and gently attach the board-to-board audio cable.
Installing the front
and rear I/O plates
VIA Technologies, Inc.
1F, 531, Zhong-Zheng Road,
Xindian, Taipei 23148
Taiwan
Tel: 886-2-2218-5452
Fax: 886-2-2218-5453
Web: www.via.com.tw
Copyright © 2010 VIA Technologies, Inc. All rights reserved.
For more information on this and
other VIA products, please visit
www.viaembedded.com.
For further support and service,
please visit www.via.com/tw/en/
products/mainboards/contact.jsp
Step 2
Align the front and rear I/O plates to the heatsink. And install the
plates screws (P/N: 99G44-030231), HDMI screws (P/N: 99G44-
010415) and hex standoff screws (P/N: 99G44-030221) to the front
and rear connectors.
Dimensions
5
4
Installing WiFi (WLAN)
module (optional)
The WiFi kit should include the WiFi module, two screws, one board-
to-board cable, one mini coaxial cable, one washer, one nut, and one
external antenna. The optional WLAN module includes a VT6656
WLAN controller and provides support for 802.11 b/g standards.
Step 1
Flip the storage chassis (bottom case) over and align the WLAN
module over the WLAN mounting holes. Then secure it with two
mounting screws.
Step 3
Gently attach the WLAN board-to-board cable to the WLAN
pinheader (USB_2/3) on the EITX-3000 board and to the mini
connector on the WLAN module.
Step 2
Insert the WLAN port (with washer) into the antenna cutout and
fasten it with the nut. Then install the external antenna, and connect
the mini coaxial cable to the mini RF connector onto WLAN module.
Step 2
Attach the other end of the board-to-board audio cable to the
pinheader (F_AUDIO) on the EITX-3000 board.
Step 1
Remove all hex standoff screws from the front & rear I/O connectors
of EMIO-3110 module.
8
Installing hard disk
and storage chassis
Step 2
Mount the hard disk brackets on the 2.5” HDD. Then install the
brackets over the HDD mounting holes on the inside of the storage
chassis and secure it with four screws. And connect the other end of
SATA (data and power) cable to the hard disk.
Step 3
Install and secure the bottom case of the storage chassis to the
heatsink with eight mounting screws (P/N: 99G44-010415).
Step 4
Align the top cover of the storage chassis with the bottom case of the
storage chassis. Then secure it with three screws (P/N: 99G44-030231).
Step 1
Connect the SATA (data and power) cable onto the EITX-3000 board.
Step 1
Insert the memory module into the SODIMM socket at 45 degrees
angle. Then push down the memory module until its snaps into place.
Installing SODIMM
and EMIO-3110
Step 2
Align the Em-IO connector on the bottom side of EMIO-3110 with the
Em-IO connector on the EITX-3000. Connect the module to the board
and secure it with six screws.
