SOM-6X50 User Manual
22
A.2.1.16. IR Receiver Sensor & Pin Header
The SOMDB1 carrier board is equipped with an IR receiver sensor & pin header which are used for connecting
IR devices to the board. The IR receiver sensor is labeled as “IR1” and the pin header as “J16”. The pinouts of
the IR receiver are shown below.
Table 18: IR receiver sensor & pin header pinouts
A.2.1.17. Debug Connector & Pin Header
The SOMDB1 carrier board comes with a debug connector & pin header which are used for debugging
purposes only. The debug connector is labeled as “J15” and the pin header as “J14”. The pinouts of the Debug
connector & pin header are shown below.
Table 19: Debug connector & pin header pinouts
SOMDB1
VTS8666C
1
J16
IR1
1
1
1
Figure 29: IR receiver sensor and pin header diagram
Pin
Signal
1
VSUS33
2
GND
3
VSUS33
Pin
Signal
1
VCC33
2
UART0RXD
3
UART0TXD
4
GND
SOMDB1
VTS8666C
1
J14
J15
1
1
1
1
Figure 30: Debug connector & pin header diagram