background image

- 7 -

REPLACEMENT PARTS

1. Circuit Board for CC-25B

2. Sensor Probe

3. Hose clamp

4. Circuit Board CC-50

5. Tubing Adaptor 

6. Fuse 

(F12a)

LIMITED WARRANTY

Commodity Axis Inc. warrants that ViaAqua® Chiller is free from defects for a period of one 

year from the initial date of purchase shown in the original cash register receipt. Commodity 

Axis Inc. disclaims all other warranties of merchantability and/or fitness for a particular 

purpose. Although this limited warranty gives you specific rights, you may have other rights 

that may vary from state to state. This Warranty is void if the failure of the ViaAqua® Chiller 

or any part, sealant or component there of is due to (i) misuse, (ii) tampering, (iii) negligence, 

(iv) misapplication, (v) abuse, (vi) accident and/or (vii) failure to properly (a) maintain, (b) 

clean, (c) pre-filter, (d) reassemble, (e) clean and/or use the ViaAqua® Chiller with a Ground 

Fault Circuit Interrupter (GFCI).

CONSUMER REMEDIES

Commodity Axis Inc. entire Liability and your sole exclusive remedy are either repair or 

replacement of the Via Aqua® chiller only if you return the defective Via Aqua® chiller 

directly to Commodity Axis Inc. with the original receipt in this original box along with 

$25.00 for shipping and handling. Do not send the chiller by insured mail. The chiller may 

be sent by UPS requiring signature upon arrival. Any replacement Via Aqua® chiller will 

be warranted for remaining of the original warranty period. In not event shall any shipping 

charges be reimbursed. In no event will Commodity Axis, Inc. be liable for any consequential 

or incidental damages including, but not limited to, loss of life, personal injury, property 

damage, damaged equipment, lost profits, lost wages, lost savings, lost income, etc. 

arising out of the use of the ViaAqua® chiller. Some states do not allow for the limitation or 

exclusion of liability for incidental or consequential damages, so the above exclusion may 

not apply to you.

For model CC-25B

For model CC-50

Summary of Contents for Polar Bear Chiller CC-25B









Reviews: