HRK3-HB-5
V
IA
L
ITE
HD
3U
CHASSIS
H
ANDBOOK
18
5.3.4
Redundancy load module, setting the load DIP switches
Detail of the DIP switch positions are given in section 5.3.3. If you wish to activate any of the resistive loads follow the sequence below.
1.
Calculate the additional load required, see section 5.1.1., 5.2 and 5.3
2.
Round this load up to the nearest three watt step
3.
Switch the appropriate number of DIP switches of SW5 to the ON position
Note. If sufficient load is not applied, it is possible for a PSU front panel power LED to be
GREEN
and the “power good” output to be LOW
(alarm state), in this case the power supply will not be registered by the
ViaLiteHD
summary alarm and SNMP and web controller cards.
5.3.5
Redundancy load module, using with SNMP and controller module
The redundancy load module is not fitted with a micro controller or I2C memory, so it is not visible on the ViaLiteHD controller GUI or
accessible via SNMP.
5.4
Power Supply HPS-CS-3 for use with OEM modules (HRx-xx-xM-xx)
The HPS-CS-3 is a Panel Mounting 12V DC output, mains input supply with a 15 way Molex connector for connection to
ViaLiteHD
OEM
modules (HRx-xx-xM-xx).
HPS-CS-3
Description
Wide input range AC power supply
Dimensions, external (W x H x D)
90 * 45 * 32 mm, supplied with mounting bracket
Lead length
1700mm typical
Weight
0.2kg
Input Supply Power
110V or 230V nominal at 50/60Hz
90 - 264V, 47-63Hz absolute range
Efficiency
83%
Output voltage
12.0 +/ -0.5Vdc
Output ripple
100mV pk-pk
Maximum output power
16 W, 1.5A @ 12V
Minimum load power
0 W
Status Indicators
GREEN
power LED
Operating temperature
-20 to +60
C, derate above +40
C
Storage temperature
-20 to +85
C
Derating >+40
C
2.4% /
C above +40
C, absolute maximum 60
C
Input protection
Over voltage protection
Output protection
Short circuit protected (Polyswitch)
Insulation class
Class 2
Power input
IEC-60320 2 pin input socket C8, supplied with matching power lead
Power output
Molex, CGRID3, 15 way socket (female)
Pin 4 = GND
Pin 5=+12V
Power connections match the requirements of
ViaLiteHD
OEM modules (HRx-xx-xM-xx)
All other pins are unconnected
Illustration of IEC-60320 2 pin input socket C8 configuration
