HRK3-HB-5
V
IA
L
ITE
HD
3U
CHASSIS
H
ANDBOOK
22
6.5
7HP Standard Plug-in Modules (slot 14 only)
All
ViaLiteHD
plug-in modules are hot-swappable, so it is not necessary to power-down the chassis before inserting a module. All standard
optical connectors are retained by the module. So it will be necessary to either disconnect any cables or have a sufficiently long service loop.
To install a 7HP Standard module
The protective covers on the connectors may be left in place.
Push the release button of the module handle down and simultaneously pull the top of the handle forwards.
Align the module upright and perpendicular to the front face of the chassis
so that the PCB slides into the “crow’s feet” card guides top
and bottom.
Gently push the module down its guide, applying pressure via the handle, you may also apply pressure between the LED and test
connector.
As the module is fully mated the top of the handle should snap back and lock in position.
The pawls of the handle should be fully engaged in the matching slots.
If power is applied to the chassis the module power LED should light as soon as the module is fully inserted
Remove protective covers and connect any interface cables
To remove a 7HP Standard module
Disconnect any cables if necessary
Push the release button of the module handle down and simultaneously pull the top of the handle forwards.
Apply pressure via the handle and gently withdraw the module from the chassis.
