Operation, Remote Operation
Scenario Commands
Rev. L0
ATC-5000NG ATC/DME Test Set Operation Manual
1-2-5
February 2020
Subject to Export Control. See Cover Page for details.
Page 79
5.7.2.21.2.A.4
INTERVAL STOP TIME
5.7.2.21.2.B
STATIC VELOCITY SCHEDULE - INTERVAL ENABLE
5.7.3
SCENARIO PARAMETERS
The following set of commands allows the user to define some scenario parameters before executing the
start of scenario.
5.7.3.1
CHANNEL GROUPING
5.7.3.2
COMPILE
Command Syntax:
{:ATC |:ATC5000NG}{:SCE |:SCENARIO}{:DYN: |:DYNAMIC:}<intruder no>{:SVEL}{:INT:
|:INTERVAL:}<interval number>{:END}SP<numeric>CR
Description:
This command sets the stop time for the selected velocity squitter message interval for the
selected intruder. The spaces not defined between intervals are considered off; therefore,
only
the user
can define
the intervals where
the message
is
transmitted
.
Numeric:
0 to 6550 seconds (decimal ASCII). Resolution is 0.1 seconds.
Example:
:ATC:SCE:DYN:1:SVEL:INT:2:END 205\r
Command Syntax:
{:ATC |:ATC5000NG}{:SCE |:SCENARIO}{:STAT: |:STATIC:}<intruder no>{:SVEL}{:ENA
|:ENABLE}SP{ON | OFF}CR
Description:
This command enables or disables the velocity squitter message of the specified intruder.
Default:
On
Example:
:ATC:SCE:STAT:1:SVEL:ENA ON\r
Command Syntax:
{:ATC |:ATC5000NG}{:SCE |:SCENARIO}{:CH |:CHANNEL}SP{1090RX1 |UATRX1|UATRX2}CR
Description:
This command allows grouping by channel commands that are used to define UAT and Multi-
Receiver scenarios.
This command
must precede
the commands
used to
define
intruders
that are
transmitted by the
specified channel
. According to the
scenario type selected, the valid arguments are:
Scenario Type
UAT
UATRX1
UATRX2
MULTI (Multi-Receiver)
1090RX1
UATRX1
Default:
Scenario Type
UAT
UATRX1
MULTI (Multi-Receiver)
1090RX1
Example:
:ATC:SCE:CH 1090RX1\r
Command Syntax:
{:ATC |:ATC5000NG}{:SCE |:SCENARIO}{:COMP |:COMPILE}CR
Description:
This command must be sent before to the Scenario Start command. This command completes
the definition of the Mode S Squitters for the intruders declared as Mode S Extended, ADS-R or
TIS-B. A “*” is returned when the compile function has been completed.
Example:
:ATC:SCE:COMP\r
Summary of Contents for 138156
Page 3: ......
