Chapter 5
Test and Measurement Functions
Overview of Test and Measurement Screens
22130634
CX300 ComXpert Operation Manual
Rev. 001
5.2.3 Test Screen Layout
The layout of CX300 test screens changes based on factors such as the selected mode of
operation, the type of measurement selected (e.g. P25 or Analog), active functions, and
provides an example of how a CX300 test screen may appear.
To Select a Mode of Operation
1.
Navigate to the
Test Home Screen
.
2.
Select the desired
mode
(e.g. Communications Test, Spectrum Analyzer and
AutoTest).
3.
Select the type of
measurement
(e.g. Analog or P25, if applicable).
4.
Select the type of measurement again,
or select the
Done
button,
to load the
selected test and measurement.
5.
Use QuickSwitch™ to quickly toggle between Duplex, Transmit, and
Receiver
Testing
.
The UI updates to display the test screen as it was configured during the last user session
for the selected mode of operation. Test Screens are divided into the following areas:
NOTE
QuickSwitch does not appear on all screens, e.g. Spectrum Analyzer, Auto-Test, etc.
Figure 5-2 Example of Test and Measurement Main Screen
