Chapter 4
Configuring System Settings
Establishing a Network Connection
22130634
CX300 ComXpert Operation Manual
Rev. 001
4.3.6 To Synchronize Time with Server Clock
The following procedure describes how to arrange and set up the test set to synchronize
time with the server clock.
1.
Arrange and set up the test set for network connectivity.
“Remotely Operating the Test Set”, on page 4-15
2.
Proceed to the
Date and Time screen
.
3.
Select the
Set Clock Automatically
check box.
4.
Enter the address for NTP Server in the drop down menu (NTP Server 1 or
NTP Server 2).
5.
Press the
OK
button
to confirm.
6.
When synchronization is complete, the time and date in the upper right corner of
the screen updates to the server time and the message “Time successfully
synchronized using NTP” is displayed on the screen.
4.4 Establishing a Network Connection
4.4.1 Establishing an Ethernet Connection
4.4.1.1 Enable Network Connectivity
Network connectivity must be enabled in order to establish a connection to an Ethernet or
WiFi network.
To Enable Network Connectivity
1.
Go to the System Screen.
2.
Select the
Network
button
.
NOTE
Requires a valid NTP server address with which to synchronize.
NOTE
When the device is configured for DHCP mode, network information is likely to change
when the device is connected, then reconnected to a network. If your procedure
requires a known IP, configure the device for Static IP network mode of operation.
Bluetooth and WiFi interfaces cannot be ON at the same time.
