Chapter 3 mA-1302/mA-1305 Setup and Installation
Module Installation
mA-1302/mA-1305 AXIe Chassis Operation Manual
Rev. D0
Page 3-10
April 2020
How to Install a Module
1
Power down the Chassis.
2
If the module has securing latches, position the latches at a 90° angle to the front of
the module.
3
Position the module on the Chassis Side Rails. Slide the module into the card cage.
4
Fully insert the module into Card Cage. Press firmly to securely connect module pins
with Backplane Assembly Connectors.
5
Press the securing latches into the Locked Position.
6
Hand tighten the captive screw on each side of module. Securely tighten each
captive screw to ensure module is properly grounded via the Chassis.
NOTE
The securing latch must be placed in the unlocked position - pulled out and away from
the latch mechanism - or module cannot be properly inserted and seated with the
Chassis backplane connectors.
Figure 3-2
Securing Latch - Locked Position
Figure 3-3
Securing Latch - Unlocked Position
Figure 3-4
Securing Latch - Unlocked and unlatched
NOTE
If the module does not slide smoothly along the side rails, remove the module, realign
and reinsert the module.
Summary of Contents for mA-1302
Page 1: ...mA 1302 mA 1305 AXIe Chassis Operation Manual ...
Page 3: ......
