80
MPOLx-84/85 (P)
9 P
ROBE
/PCM O
PERATION
O
PERATION
If no matching adapter/tip is available, a standard brightness will
still provide an image, while the pass/fail analysis algorithm
might not work properly.
To select a adapter/tip:
1.
Press the
[
A
]
key.
2.
Tap the
[
Tip
]
/
[
Adapter
]
button.
3.
Select the suitable adapter/tip.
Operation
For MPO tests: positioning the ribbon
J
Use the two screws at the FMA-MTPA adapter to position a
fiber in the center of the display.
Adjusting the focus
J
Use the focus control to adjust the sharpness.
NOTE:
The focus quality bar helps you to find the best setting (see
“Focus quality bar” on page 78
).
Adjusting the magnification
J
Press the Magnification Control key to modify the live display
from high to low magnification and vice-versa.
In the high magnification mode, automatic centering is
available.
Running a test
J
Press the
[
A
]
key and tap the
[
Test
]
button.
– or –
Press the QuickCapture™ key if the button action is set to
Test
.
