84
MPOLx-84/85 (P)
10 W
ORKFLOW
MODE
P
ERFORMING
A
MEASUREMENT
IN
W
ORKFLOW
MODE
10
W
ORKFLOW
MODE
To work in the Workflow mode, tasks are first transferred via the
Mobile Application from a mobile device to the MPOLP-85(P).
Then the tasks are just executed as set up by the project
manager in the Cloud-based Project Management application
CERTiFi.
Thus, this chapter just explains how to handle the tasks and
routines as part of the Workflow-Mode. The measurements
themselves are part of the Test-Tool mode and described in the
corresponding chapters.
The workflow mode can be enabled only through Viavi's Cloud-
based Enterprise Workflow Management Tool CERTiFi. For more
information please refer to www.viavisolutions.com
Performing a measurement in Workflow
mode
A complete measurement in Workflow mode consists of
following steps:
1.
Define a project in the Cloud-based application CERTiFi. This
is usually done by a project manager.
2.
Transfer the project to the instrument via the Mobile App
(please refer to the help provided with the App).
3.
In the instrument select a project and set it to active.
4.
Select a label list (if the project contains more than one) and
set it to active.
5.
Start the measurement and perform each measurement
defined for each label.
6.
Save the measurement.
When synchronized the progress of each measurement is
displayed in the Mobile and Cloud Apps.
7.
If a test has failed the device under test may be checked and
tested again to get a passed result.
These steps are described in detail in the following sections.
Defining a project in the Cloud-based application
CERTiFi
This is usually done by a project manager.
NOTE:
For further information about the Cloud Application please refer
to the help provided with the application.
