Vibe DSX11, Setup Information Manual

P.5

☆ Transmitter Setup For The XG8

JR-CCPM plays a critical role in coordinating the simultaneous activating of multiple servos to control 
the swashplate. Activation of just a single servo would not lead to control of the swashplate - the three 
swashplate servos must be controlled in a coordinated fashion. The setup of these servos differs from that for 
other control functions which control just one servo (for example, the Rudder).
The initial settings given here must be confirmed on the bench, and then fine tuned after test flying the 
helicopter. Prior to commencing this process, confirm all the trim levers and trim knobs on the transmitter are in 
their neutral (zero) positions. Also shift all switches to position”0” (switches moved away from the operator).

Please also be familiar with the instructions for the transmitter. The initial settings can be entered into the 
transmitter without turning power on to the receiver. Please note that fine adjustment will be needed after test 
flying the helicopter.

1. Initial Radio Setup

① Turn on the power switch and press the 【LST】 key 

located on the lower of the transmitter.

「FUNCTION LIST 1/3」 screen displayed.

② Press the 「FNC」 key twice to display 「FUNCTION 

LIST 3/3」 and then turn the dial to select 「 ▶ SYS. 
LIST」and press.

③「SYSTEM LIST 1/2」 screen displayed.
Turn the dial to select 「MODEL SEL.」 and press.

④「RF-POWER OFF?」 is displayed.
Press the 【CLR】 key to select 「YES」.

⑤ Current model No. is displayed.
Turn the dial to select this area and press.

⑥ Turn the dial to select the model No. which can be 

reset and press.

⑦ Use the 【LST】 key to return to 「■ SYSTEM LIST」. 

Turn the dial to select 「COPY/ERASE」 and press.

② Select 「SYS. LIST」

③ Select 「MODEL SEL.」

⑤ Turn the dial to 
select.

⑦ Select 「COPY/ERASE」

④ Select 「YES」

⑥ S e l e c t   t h e 
model to be reset.

④

② , ③
⑤〜⑦

①

①

②

②